#CATEYE STRADA BATTERY CHANGE TV#

Enter the front wheel tire circumference of your bicycle in mm.

1 Clear all data (initialization) Press the AC button on the back of the computer.

After letting the battery compartment dry out, we had no issues with the computer. We did have some moisture get into the battery compartment after transporting it on a vehicle roof rack in a rainstorm. How do I reset my Cateye Strada Wireless?Ĭateye claims that the Velo 7 is water resistant, but does not reference any particular standard. don’t worry it alright its going to take some pressure to release it but push with your thumb away and toward the front of your bike and it will resease. Place the pad of your thumb on the lowest of the bottom of the Cateye computer, apply firm direct pressure away from the bracket.

Switch off the functions you want to skip by moving to the relevant icon and turning the setting off.

Press MODE to display the screen shown below, and then press MODE for 2 seconds.

From the measurement screen, press MENU to switch to the menu screen.This is the most accurate wheel calibration number.How do you change the battery in a Cateye Strada Wireless? With the riders weight on the bike, roll the wheel one tire revolution in a straight line and mark the ground when the valve stem is perpendicular to the ground again. With the valve stem perpendicular to the ground, mark the pavement at the valve stem. 24h ↔ 12h, or increase the value Switch the screen or move digits (by pressing & holding) Preparing the computer Battery case cover Push! When the computer is mounted on the bracket : Speed unit : Wheel size icon : Sensor signal reception icon Measure wheel circumference (L) of your bike To get the most accurate calibration do a wheel roll out. Set the clock When MODE is pressed and held, “Displayed time”, “Hour”, and “Minute” will appear, in this order. * Refer to the tire circumference reference table. Enter the tire circumference Enter the tire circumference of your bicycle in mm. Select the desired speed units Select “ ” or “ ”. Modifications The FCC requires the user to be notified that any changes or modifications made to this device that are not expressly approved by CatEye Co.,Ltd.May void the user ’s authority to operate the equipment.Ĥ km/h ↔ mph Increase Move digits (by pressing & holding) Register the setting Register the setting Clear all data (initialization) Press the AC button on the back. This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:(1)This device may not cause harmful interference,and (2)this device must accept any interference received,including interference that may cause undesired operation. Using with other wireless devices in close proximity.

#CATEYE STRADA BATTERY CHANGE TV#

Close to a railroad crossing, railway tracks, TV stations and/or radar base.

Near a TV, PC, radio, motor, or in a car or train.

Interference may occur, resulting in incorrect data, if the computer is:

Signals can be received only when the back of the computer is facing the sensor.

The transmission distance may be shorter due to low temperature or low battery.

Signals cannot be received if the distance between the sensor and the computer is too great.

When adjusting the wireless sensor, note the following: Wireless Sensor The sensor was designed to receive signals within a maximum range of 70 cm, to reduce chance of interference.

LCD screen may be distorted when viewed through polarized sunglass lenses.

Dispose of used batteries according to local regulations.When cleaning the computer, bracket and sensor, do not use thinners, benzene, or alcohol.Over-tightening can damage the bracket threads. Tighten the dial on the Flex-Tight bracket by hand only.Pressing hard on other areas can result in malfunction or damage to the computer. When using the computer installed on the bracket, change the MODE by pressing on the three dots below the screen.

Cateye strada battery change